Turbosmart WASTEGATES – EXTERNAL - Hyper-Gate45 (with locking Instrukcja Użytkownika Strona 4

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 9
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 3
www.TURBOSMARTONLINE.com
4
IMPORTANT NOTES ON SETTING THE WASTEGATE SPRING PRESSURE
A stiffer spring should only be used when necessary. The Hyper-Gate45 allows for different combinations of spring pressures. All
springs that are adaptable with the Hyper-Gate45 are shown in the table below. The tuner can use combinations of up to 3 springs to
achieve the following base boost pressures. To aid in the identification of these springs they are supplied colour coded. If this colour
coding is not clear please use the dimensions in the following table to identity the wastegate spring. Please see the following detailed
instructions on setting your Hyper-Gate45’s spring pressure. The springs chosen should be rated to the lowest boost level desired.
Pressure rating 3 PSI Inner 5 PSI Inner 7 PSI Middle 11 PSI Middle 10 PSI Outer 7 PSI Outer
Part number TS-0505-2001 TS-0505-2002 TS-0505-2003 TS-0505-2004 TS-0505-2005 TS-0505-2006
Colour BRN/BLK BRN/GRY BRN/PUR BRN/RED BRN/BLU BRN/PNK
Dimensions
29mm OD,
32mm Length
29mm OD,
36mm Length
36.5 OD, 43mm
Length
36.5 OD,
52mm Length
44mm OD, 68mm
Length
44mm OD,
57mm Length
Desired Boost
Pressure
PSI BAR KPa
3 0.207 20.68
5 0.345 34.47
7 0.483 48.26
10 0.69 68.95
11 0.76 75.84
12 0.827 82.74
13 0.89 89.6
14 0.965 96.53
15 1.03 103.4
16 1.1 110
17 1.172 117.2
19 1.31 131
20 1.38 138
21 1.45 145
22 1.517 151.7
23 1.59 159
24 1.655 165.5
26 1.793 179.3
Changing the springs
WARNING! Fitting a heavier wastegate spring may cause a higher than expected increase in boost pressure.
Turbosmart recommends adjusting your boost controller back to its minimum setting and measuring the new minimum boost pressure
achieved by the new spring, before increasing your boost pressure again.
Przeglądanie stron 3
1 2 3 4 5 6 7 8 9

Komentarze do niniejszej Instrukcji

Brak uwag