Turbosmart BOOST CONTROLLERS – ELECTRONIC - e-Boost2 (2005-cu Instrukcja Użytkownika Strona 5

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 38
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 4
www.TURBOSMARTONLINE.com
5
Wiring
- The e-Boost2 must be connected to a typical automotive12 volt negative earth electrical system.
- Soldering or Crimp on electrical connectors must be used on all electrical connections
- Unused wires must be insulated with electrical tape so that they do not touch other wires or the chassis
- Refer to the following table and diagram for detail on wiring the e-Boost2.
Wire Connect to
RED + 12 Volts switched through ignition – connect via 5 Amp fuse supplied
BLACK Chassis, earth or ground
GREY Solenoid wire 1 – connect using wire supplied – polarity not important
BROWN Solenoid wire 2 - connect using wire supplied – polarity not important
YELLOW RPM signal from ECU or negative terminal of an ignition coil OPTIONAL
WHITE Auxiliary output – switched to ground – see diagram below OPTIONAL
GREEN External set point switching OPTIONAL
ORANGE External set point switching OPTIONAL
Przeglądanie stron 4
1 2 3 4 5 6 7 8 9 10 ... 37 38

Komentarze do niniejszej Instrukcji

Brak uwag