Turbosmart BOOST CONTROLLERS - Dual Stage Boost Controller Instrukcja Użytkownika Pobierz pdf

------------------------------------------------------------------------------------------------------------------------

ABOUT THIS PRODUCT

Thank you for purchasing your new DSBC. This new model now has some great new features. These include:

• 2 ramp rates of boost to give you the option of a fast rise in boost or a slightly tame rise for more sensitive setups.

• A wider boost adjustment range for wastegates with low spring base pressures.

IMPORTANT NOTES ON YOUR BOOST CONTROLLER

• Use only silicone hose that is the correct size and pressure rating for your application when fitting your boost controller – other

hoses will be effected by heat and will eventually crack or split which could cause excessive boost pressure and engine damage

• Ensure that all plumbing is secured with clamps

• Your boost controller should be mounted at least 100mm from any heat source

• A Turbosmart Fuel Cut Defender may need to be used in conjunction with your boost controller – refer to www.turbosmart.com.au

• The boost dials have a left handed thread, be sure not to over tighten as this will damage the boost controller

RECOMMENDATIONS

• Turbosmart recommends that the Air Fuel ratio is checked once boost pressure is set

• Turbosmart recommends that boost pressure is set using a Dynamometer and not on the street

• Turbosmart recommends that a accurate boost gauge be permanently fitted to the vehicle

• Turbosmart recommends that your boost controller is fitted and adjusted by an appropriately qualified technician

------------------------------------------------------------------------------------------------------------------------

HOW TO INSTALL YOUR BOOST CONTROLLER

TOOLS REQUIRED

General mechanic tools

ELECTRICAL CONNECTION

 The white wire is positive and the Black wire is negative

 Supplied wiring can be split if needed to extend wiring to the appropriate areas

 Extend the white wire using the supplied black with white trace wire through the supplied switch to a fused 12 volt ignition

supply – Important, failure to connect to an ignition supply may cause the battery to go flat and may result in damage to the

product

 Check that the power source can accept an additional 1amp load

 Connect the black wire on the unit, with crimp supplied, to a solid ground point on the chassis. Use the supplied black wire to

extend if needed.

Product Name: Dual Stage

Product Description: Dual stage boost controller

Product Number: TS-0105-1001/TS-0105-1002

1 2 3 4 5

BOOST SPIKING 4
Happy motoring! 5

Podsumowanie treści

Strona 1

1 ------------------------------------------------------------------------------------------------------------------------ ABOUT THIS PRODUCT Thank

Strona 2

2 1) INTERNAL WASTEGATE SETUP • Allow the engine to cool down before installing your boost controller • Locate the pressure source port and the was

Strona 3

3 3) PARALLEL TWIN TURBO SETUP • Allow the engine to cool down before installing your boost controller • Locate the wastegate actuator ports on bo

Strona 4 - BOOST SPIKING

4 SETTING BOOST PRESSURE IMPORTANT NOTES ON BOOST PRESSURE ADJUSTMENT • Adjustment to your boost controller is made by rotating the Boost Dials

Strona 5 - Happy motoring!

5 ONE YEAR LIMITED WARRANTY Turbosmart is a company built on Customer Satisfaction and Service. That is why all of our products go through regi

Komentarze do niniejszej Instrukcji

Brak uwag

Turbosmart BOOST CONTROLLERS - Dual Stage Boost Controller Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Do samochodu Turbosmart BOOST CONTROLLERS - Dual Stage Boost Controller. Turbosmart BOOST CONTROLLERS - Dual Stage Boost Controller User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Do samochodu Turbosmart BOOST CONTROLLERS - Dual Stage Boost Controller